So, last night I put my main gear in place and then did a couple of rotations with the gear to see where I should be cutting my wheel wells on the wings. After doing this I wasn't to sure if I was right so could anyone help with this, I'll try and make it as simple as possible.
In the picture you will see that I have the vertices selected on the top of the gear strut, I need the strut and wheel to rotate 90 deg (from the vertices highlighted) so that the wheel faces backwards then I need the strut and wheel again to rotate from the same vertices point up into the wheel well I have cut out. Can I specify in the animations that those points I want to rotate from are where it does rotate from? (if you understand)
I have also found that the wheel strut actually angles forward slightly, will that make any difference?
Many thanks