Board index FlightGear Support

How to add flight plan from cmd and activate route manager?

All general support: help on flying, installation, hardware, getting online etc. There are lots of users and developers to help you out.
Forum rules
In order to help you, we need to know a lot of information. Make sure to include answers to at least the following questions in your initial post.

- what OS (Windows Xp/Vista, Mac etc.) are you running?
- what FlightGear version do you use?
- what graphics card do you have?
- does the problem occur with any aircraft, at any airport?
- where did you download your aircraft/scenery from?
- is there any output printed to the console (black window)?
- copy&paste your commandline (tick the "Show commandline box on the last page of FGRun or the "Others" section on the Mac launcher).

Please report any bugs not specific to an aircraft on the issue tracker.
To run FlightGear on old computers with bad OpenGL support, please take a look at this wiki article.

Note: If you did not get a reponse, even after 7 days, you may want to check out the FlightGear mailing lists to ask your question there.

How to add flight plan from cmd and activate route manager?

Postby Zohair43 » Mon Sep 03, 2018 11:04 am

I am using Flightgear 2018.2.2 on Windows 10 and cant seem to figure out a way to automatically load the Flight Plan XML and run it as soon as the Flightgear starts.

The command I am using is:

fgfs --aircraft=737-300 --lon=151.177222 --lat=-33.946111 --altitude=10000 --heading=220 --vc=280 --airport=YSSY --fdm=jsb --flight-plan=plan.xml --prop:/controls/gear/gear-down=0 --prop:/autopilot/settings/target-speed-kt=280 --prop:/autopilot/locks/speed=speed-with-throttle --prop:/autopilot/settings/target-altitude-ft=10000 --prop:/autopilot/locks/altitude=altitude-hold --prop:/autopilot/locks/heading=true-heading-hold --prop:/autopilot/route-manager/destination/airport=YSCB --prop:/autopilot/route-manager/destination/runway=34 --prop:/autopilot/route-manager/departure/runway=34L --prop:/autopilot/route-manager/input=@INSERT-1:YSCB --prop:/autopilot/route-manager/airborne=true --prop:/autopilot/route-manager/active=true
Zohair43
 
Posts: 1
Joined: Mon Sep 03, 2018 10:38 am

Re: How to add flight plan from cmd and activate route manag

Postby TribalBob » Tue Sep 04, 2018 6:27 pm

You have one or both of two problems.

Make sure --flight-plan is pointed to the right location. For example, when i save a route, it gets saved to: C:\Users\MyUsername\AppData\Roaming\flightgear.org\Export\plan
So in order to load the flightplan I must set --flight-plan=C:\Users\MyUsername\AppData\Roaming\flightgear.org\Export\plan

Secondly, make sure the file is actually an XML file, by default FlightGear saves routes without a file extension.

As far as automatically activating the route, I can't help with that. I will have to do some testing.
TribalBob
 
Posts: 47
Joined: Thu Aug 23, 2018 11:58 am


Return to Support

Who is online

Users browsing this forum: No registered users and 2 guests