Like the right decount for Body axis velocity
Yeah, I went through the Insertion/De-orbit workbook and added a bunch of small things here and there...
Like the right decount for Body axis velocity
OMS burn for -2163 seconds
OMS burn for -2163 seconds
OMS burn for -2163 seconds
OMS burn for -2163 seconds
OMS burn for -2163 seconds
OMS burn for -2163 seconds
OMS burn for -2164 seconds
OMS burn for -2164 seconds
OMS burn for -2164 seconds
OMS burn for -2164 seconds
OMS burn for -2164 seconds
OMS burn for -2164 seconds
Using the development branch, no payload, target 165 miles, 32.50 inclination the roll heads up causes a sink rate of up to 100 m/s. It recovered well, and I achieved orbit. I presume the sink rate is normal?
Also, is the propellant dump also done automatically now?
Also, following http://wiki.flightgear.org/Flying_the_S ... n_Advanced something went a bit wrong
My console is also filled with such messages
And when I try to execute the payload bay attitude maneouver
Gone are the days of simple spaceflight
Edit: and while correcting the vector after completing the maneouver, I went into an uncontrolled spin due to excessive pilot inputs . After I recovered from that, I found myself in an increasing sink!
But indeed , I found that the smallest mistake in Bêta angle or AOA before Nz hold could lead to LOC easily
When you will have time Thorsten, could you try a RTLS around 3 mn for the failure.
Standard 32 degrees orbit inclination .
I also wanted to test some engine stuck procedure . Expect shutting down an APU when thrust is at 67 %, is there a way to put an engine at 67% of thrust while the others remain at full thrust?
GinGin wrote in Fri May 18, 2018 6:59 am:
You didn’t answer, where you using advanced gpc settings or simplified one?
This is probably I have not updated my FlightGear nightly build for a few weeks,
However, when I use the "replicate CRT" button in the menu, the canvas window that comes up is transparent, with only the text displayed.
Users browsing this forum: No registered users and 0 guests