by wkitty42 » Tue Feb 27, 2018 6:17 pm
yep... here's what i use when running ATC-PIE and OpenRadar... i use 5010 for ATC-PIE, 5015 for OpenRadar, and 5009 for MP... if i'm reading it right, that is, it has been several months since i ran two or three FG sessions at the same time with either of the ATC tools...
this is from my ATC-PIE viewer...
- Code: Select all
RUNCMD="$MYFGNEXTDIR/run_fgfs.sh --aircraft=ufo --telnet=,,100,,5010, --multiplay=in,100,,5010 --multiplay=out,100,shadow,5009 --lat=-7.308276 --lon=72.411587 --altitude=157.92 --heading=360 $@"
this is from my OR viewer...
- Code: Select all
RUNCMD="$MYFGNEXTDIR/run_fgfs.sh --aircraft=ORCAM --telnet=,,100,,5015, --multiplay=in,100,,5015 --multiplay=out,100,shadow,5015 --callsign=OR_Obs $@"
then i have my regular FG session just on the MP network... i haven't tried setting up one FG session with both sets of the above combined and use either or both ATC tools at the same time but the main one doesn't care since it just uses the MP network to see and talk to them... plus i use port 8080 so i can connect to the Phi web interface as well as one of my (python) tools that reads some data out of the property tree
"You get more air close to the ground," said Angalo. "I read that in a book. You get lots of air low down, and not much when you go up."
"Why not?" said Gurder.
"Dunno. It's frightened of heights, I guess."