Board index FlightGear Support Interfacing

What am I missing..?

Connecting two computers, using generic protocol, connecting with Matlab?

What am I missing..?

Postby aprecelton » Sun Aug 20, 2017 10:49 pm

Hello All
Could someone help?
I am interfacing 2 computers, one a Mac, the other a pc which in the past I've been able to network using the UDP protocol from the wiki document multicomputer set up, where the pc is the slave to the mac. Mac runs FDM and controls, and the pic has a null FDM and receives the info from the Mac.
Since updating the the latest release of FG, I can't seem to get the 2 computers to communicate. I have disabled the firewall on the pc in case it was a firewall issue, and they are both on the same network. I double-checked to see if the port numbers match.

Any ideas of what I could try?
Thank you. :)
Posts: 31
Joined: Fri Feb 26, 2016 10:20 am

Return to Interfacing

Who is online

Users browsing this forum: No registered users and 0 guests