As you can see it is still about 10 ft above ground, I rotated the camera around to visualize it better. I'll try again using just the binary nightly and fgdata if that will make a difference?
<!-- ******************************************************************* -->
<!-- Cockpit Commander Joystick -->
<!-- ******************************************************************* -->
<model>
<path>cockpit-joysticks-cmdr.xml</path>
<offset>
<x-m> 0 </x-m>
<y-m> 0 </y-m>
<z-m> 0 </z-m>
</offset>
</model>
Thorsten wrote in Mon Sep 28, 2015 11:40 am:Well, fellow Shuttle users - do you know your manual? Here's a little quiz I came up with while testing failure modes and how they show on the GNC SYS SUMM 2 display.
The following five screens show each an off-nominal condition. The relevant fault message has been cleared already (otherwise it'd be easy). Can you spot what's wrong (first series of hints after the screenshots)?
Could you add these files to the Models sub-folder and add the following code to SpaceShuttle.xml in the same folder
I am still not sure if they all move in unison or only based on some computer setting.
Such a page could be of real help to new users, to help understand the complexities of the shuttle.
Thorsten wrote in Mon Sep 28, 2015 12:10 pm:Well, the OMS/RCS systems modeling is now 80% of what the real thing does (you get meaningful pressures, valve settings, fault detection,...) so you might as well read the actual manual rather than a wiki page. Less work for me.
Users browsing this forum: No registered users and 1 guest