TWRackers wrote:Okay, in UV Face mode I could see the faces flipping if I recalculated inside, then outside. I then re-exported to a .ac file and changed my .xml file to refer to the .ac file instead of the .wrl file. When I run FG, at the point it's loading the aircraft it prints "Unknown exception in the main loop. Aborting..." and dies. What could cause that?
I'm constantly getting contradictory instructions as to whether the tag should be <heading-deg> or <heading-offset-deg> or <yaw-offset-deg> or whatever. In this case <heading-deg> was the only one that worked. I haven't found the howto you mentioned; is it on my system? I haven't looked.... Oh, there it is, except it's under Docs-mini. I'll have to take a look at it. Thanks for the tips.AndersG wrote:Adjusting the position and orientation of the model can be done by an <offset>-element following the <path>-element in the model xml file. E.g.
<offsets>
<heading-deg>-10</heading-deg>
<pitch-deg>10</pitch-deg>
<roll-deg>42</roll-deg>
<x-m> 39.60 </x-m>
<y-m> 0.40 </y-m>
<z-m> -19.55 </z-m>
</offsets>
Have you found data/Docs/model-howto.html yet?
/Anders
TWRackers wrote:I'm constantly getting contradictory instructions as to whether the tag should be <heading-deg> or <heading-offset-deg> or <yaw-offset-deg> or whatever. In this case <heading-deg> was the only one that worked.
Users browsing this forum: No registered users and 9 guests