Hello there!
Thank you for your feedback and for using RedGriffin ATC. Also thanks for your appreciation about my addon.
Oswald wrote in Sun Nov 22, 2020 6:59 pm:If I decide to not follow ATC advise, how can I switch it off? My approach to WAJJ was either faulty in ATC advise, or in my following it, either way I deemed abortion of landing incorrect and being distracted by from my point of view wrong ATC information (partly leading me into nearby mountains) might had needed a button like "please be quiet, I land anyway".
In case you want to stop getting ATC assistance while you are approaching an airport, you can either push the "abort approach" or "abort landing" buttons and the ATC will give you a "go around" message and after that it will not give more assistance, saved the warnings about terrain, in case they are enabled.
Another way is to change radio frequency or turn it off.
In the forthcoming 2.1.0 version, which is under development, I however added a menu item to completely turn RedGriffin ATC on or off.
Oswald wrote in Sun Nov 22, 2020 6:59 pm:Second: It takes a lot of additional system performance from my computer which is at the limit with a more complicated aircraft and VA connection anyway.
This is strange because I continuously check both resource and time consumption in Red Griffin ATC and, as far as I can tell by verifying this in my machines the consumption is quite low. Red Griffin ATC basically is a timer based application which "wakes up" the addon at specific intervals. I will however check this again.
Can you please provide me the aircraft you are using and your configuration so I can test it here?
Thank you for your feedback and support.
Enjoy Red Griffin ATC!