Bear Buck:
Very pleased it was not just me! Thanks for confirming this. I shall now start working on a Qantas livery..... Thanks again. Regards. Upkeep.
Buckaroo wrote:I hope this is in time for testing before FS Weekend. 'd hoped to finish earlier, but I've been doing over-time hours at work the last two weeks and got swamped. Yakko has been extremely helpful in testing this release, and deserves kudos.
Buckaroo wrote:Blender3D,
Is it possible you are referring to the 1049G that is in the Flightgear repository and download page, rather than the 1049H found on my site (shown in my sig line below)? My instruments are not at all flat (unless someone took a hammer to them), and most engineering instruments and controls are in place. A few gauges are not present-- the prop sync instrument, oil quantities and a small number of other things that have no system modeling yet, and a few elements lack functionality, such as aux fuel pump switches and prop syncing controls. The only major panel that is not represented at all is the sta 260 panel on the aft cockpit bulkhead which is mostly fire and climate controls.
-Buck
Yakko wrote: I was kind of worried that, since you're using a prerelease build of FG, it may not work exactly right on your version - it was tested and tuned for version 2.0.0 and I know the prerelease interim builds change almost daily. So I am relieved that you are getting proper performance.
Buckaroo wrote:Sorry about the livery situation, Durk. I was concerned about that when you earlier mentioned a KLM livery. The changes were necessary, and will give superior ability to create complete liveries. A contributor has already created a nice new Lufthansa livery to add to the others, and I'd love to add the KLM livery if/when you care to release it.
Users browsing this forum: No registered users and 6 guests