Board index FlightGear Support Interfacing

Joystick Calibration

Connecting two computers, using generic protocol, connecting with Matlab?

Joystick Calibration

Postby Robertfm » Wed Nov 13, 2019 5:43 pm

Not sure if this is the right area. The calibration tool was working just an hour ago when I adjusted a couple of settings now all I am getting is this when I open it. The drop down menu doesn't work. I closed the sim and opened it again but still the same.

Posts: 1335
Joined: Thu Apr 25, 2019 4:56 pm

Return to Interfacing

Who is online

Users browsing this forum: No registered users and 1 guest