Board index FlightGear Support Interfacing

Trouble with Simulink FDM

Connecting two computers, using generic protocol, connecting with Matlab?

Trouble with Simulink FDM

Postby d165131 » Thu Sep 13, 2018 11:17 am

I am currently working on a project to connect Simulink FDM to flight gear.
What I want to achieve is to use the Simulink FDM and engine models to replace their counterparts inside Flight gear.

In Simulink I have the FDM model, I also have engine models and landing-gear models. The Simulink and F/G is connected by the Aero toolbox of Simulink.

The issue is I can't start the engine. Although the Simulink models can run together with F/G.

Has anyone done the similar thing before?
d165131
 
Posts: 2
Joined: Thu Sep 13, 2018 10:39 am

Return to Interfacing

Who is online

Users browsing this forum: No registered users and 3 guests