Board index FlightGear Support Interfacing

Bidirectional serial comunication

Connecting two computers, using generic protocol, connecting with Matlab?

Bidirectional serial comunication

Postby dreamgame » Thu Jun 21, 2018 12:51 am

Hello to all. First post on this board.

I am developing some AP controls with an Arduino, and i have some days fighting on this.

I can send data to my Arduino correctly, all works fine, and i can blink some leds from the simulator. But when i change on the additional settings, from out to bi the generic protocol. Things stops working.

FG starts to send repeatedly randoms chars, or only semicolons, or sometimes nothing at all. And of course, ignores all that my arduino is sending. Note that semicolon was set to be the variable separator.

As i readed here and some other posts:

viewtopic.php?f=36&t=16242
viewtopic.php?f=36&t=12893&p=143304&hilit=serial+bidirectional+io#p143304

Seems like the bidirectional serial protocol is not working. Can someone please confirm?

I am running FG 2018.1.1 on a Debian 10 Buster.
dreamgame
 
Posts: 1
Joined: Thu Jun 21, 2018 12:31 am

Return to Interfacing

Who is online

Users browsing this forum: No registered users and 1 guest