Board index FlightGear Support Interfacing

Telnet & parking brake

Connecting two computers, using generic protocol, connecting with Matlab?

Telnet & parking brake

Postby kbumbaz » Fri Jun 08, 2018 1:38 pm

Hi all,

I am testing some interface and specially the telnet one with the C127p.

When I do
set /controls/flight/aileron 1
set /controls/flight/aileron 0
set /controls/flight/aileron -1

I can see the yoke moving, right center and left.

same for strobes, on off working.

But when I do
set /controls/gear/brake-parking 0
> I can't see the parking brake lever moving
(also tested with setd setd)
get /controls/gear/brake-parking
> return me 1 (as it is inside the cockpit) dispite my set to 0.

Is it read only ?
I am planning a cockpit panel and I feel bad without a parking brake button :)

I have not checked all others right now.

Thank you all for your help.
kbumbaz
 
Posts: 2
Joined: Tue Jun 05, 2018 7:00 am

Return to Interfacing

Who is online

Users browsing this forum: Applebot [Bot] and 1 guest