Bencine mixture 90%, throttle at 20%,Alternator and bateries on,both magnetos,starter key on.. and always "use premier", but never start. I can´t know what is wrong.
Can somebody help me?
FlightGear Forum
Board index ‹ FlightGear ‹ Support ‹ Flying
Start the engine Cesna
2 posts
• Page 1 of 1
Start the engine Cesna
by Javier2021 » Mon Apr 05, 2021 11:55 am
- Javier2021
- Posts: 1
- Joined: Mon Apr 05, 2021 11:36 am
Re: Start the engine Cesna
by wkitty42 » Mon Apr 05, 2021 1:29 pm
assuming i have read and understood your post correctly, have you actually used the primer? it is left and i think lower than the battery switch... you have to click it twice for one pump... once to pull out, once to push it in... so at least six click for three pumps... and you have to click slowly waiting for the slider to finish moving before the next click...
i was going to try google translate for you but these forums don't (yet) handle UTF-8 characters... sorry
i was going to try google translate for you but these forums don't (yet) handle UTF-8 characters... sorry
"You get more air close to the ground," said Angalo. "I read that in a book. You get lots of air low down, and not much when you go up."
"Why not?" said Gurder.
"Dunno. It's frightened of heights, I guess."
"Why not?" said Gurder.
"Dunno. It's frightened of heights, I guess."
-
wkitty42 - Posts: 9161
- Joined: Fri Feb 20, 2015 4:46 pm
- Location: central NC, USA
- Callsign: wk42
- Version: git next
- OS: Kubuntu 22.04
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests