Board index FlightGear Support

Slave camera's position updation

All general support: help on flying, installation, hardware, getting online etc. There are lots of users and developers to help you out.
Forum rules
In order to help you, we need to know a lot of information. Make sure to include answers to at least the following questions in your initial post.

- what OS (Windows Xp/Vista, Mac etc.) are you running?
- what FlightGear version do you use?
- what graphics card do you have?
- does the problem occur with any aircraft, at any airport?
- where did you download your aircraft/scenery from?
- is there any output printed to the console (black window)?
- copy&paste your commandline (tick the "Show commandline box on the last page of FGRun or the "Others" section on the Mac launcher).

Please report any bugs not specific to an aircraft on the issue tracker.
To run FlightGear on old computers with bad OpenGL support, please take a look at this wiki article.

Note: If you did not get a reponse, even after 7 days, you may want to check out the FlightGear mailing lists to ask your question there.

Slave camera's position updation

Postby sdefvisual » Thu Mar 18, 2021 1:31 pm

Hello,
Using Flight Gear 2017.3.1 version can we able to update the slave camera's position independently(without affecting the Master camera's position).
sdefvisual
 
Posts: 27
Joined: Wed Mar 25, 2020 12:40 pm

Re: Slave camera's position updation

Postby Hooray » Fri Mar 19, 2021 2:49 pm

Please don't send support requests by PM, instead post your questions on the forum so that all users can contribute and benefit
Thanks & all the best,
Hooray
Help write next month's newsletter !
pui2canvas | MapStructure | Canvas Development | Programming resources
Hooray
 
Posts: 12707
Joined: Tue Mar 25, 2008 9:40 am
Pronouns: THOU


Return to Support

Who is online

Users browsing this forum: No registered users and 5 guests