Board index FlightGear Support

Re: North American Aviation P-51 D-25-NA failed to extract

All general support: help on flying, installation, hardware, getting online etc. There are lots of users and developers to help you out.
Forum rules
In order to help you, we need to know a lot of information. Make sure to include answers to at least the following questions in your initial post.

- what OS (Windows Xp/Vista, Mac etc.) are you running?
- what FlightGear version do you use?
- what graphics card do you have?
- does the problem occur with any aircraft, at any airport?
- where did you download your aircraft/scenery from?
- is there any output printed to the console (black window)?
- copy&paste your commandline (tick the "Show commandline box on the last page of FGRun or the "Others" section on the Mac launcher).

Please report any bugs not specific to an aircraft on the issue tracker.
To run FlightGear on old computers with bad OpenGL support, please take a look at this wiki article.

Note: If you did not get a reponse, even after 7 days, you may want to check out the FlightGear mailing lists to ask your question there.

Re: North American Aviation P-51 D-25-NA failed to extract

Postby tonimark » Wed Jan 29, 2020 11:44 am

Hello, I hope this is the right place to report an error with the aircraft downloader. The P-51 will download but has an error message saying that it failed to extract. The button on the add-on then says "Update", but is not clickable. I can install all other aircraft just fine. I've tried the P-51 on both my laptop and my desktop; same deal. I'm using the default hangar. , previously, I viewed a thread about the same error and tried the link: http://mirrors.ibiblio.org/flightgear/f ... t/p51d.zip
I extracted the file at C:\Users\pc\Documents\FlightGear\Aircraft\org.flightgear.fgaddon.trunk\Aircraft
when I loaded FlightGear the same aircraft was available for update and also I couldn't fly it. when the download was finished I got the same error as before, I waited for replies but nothing happened, so I decided to create a new thread for some attention
tonimark
 
Posts: 11
Joined: Wed Feb 14, 2018 1:46 pm

Return to Support

Who is online

Users browsing this forum: Google [Bot] and 1 guest