- Code: Select all
Bus 002 Device 033: ID 06a3:0d67 Saitek PLC
Device Descriptor:
bLength 18
bDescriptorType 1
bcdUSB 1.00
bDeviceClass 0 (Defined at Interface level)
bDeviceSubClass 0
bDeviceProtocol 0
bMaxPacketSize0 8
idVendor 0x06a3 Saitek PLC
idProduct 0x0d67
bcdDevice 1.10
iManufacturer 1 HOLTEK
iProduct 2 Saitek Pro Flight Switch Panel
iSerial 0
bNumConfigurations 1
Configuration Descriptor:
bLength 9
bDescriptorType 2
wTotalLength 34
bNumInterfaces 1
bConfigurationValue 1
iConfiguration 0
bmAttributes 0x80
(Bus Powered)
MaxPower 36mA
Interface Descriptor:
bLength 9
bDescriptorType 4
bInterfaceNumber 0
bAlternateSetting 0
bNumEndpoints 1
bInterfaceClass 3 Human Interface Device
bInterfaceSubClass 0 No Subclass
bInterfaceProtocol 0 None
iInterface 0
HID Device Descriptor:
bLength 9
bDescriptorType 33
bcdHID 1.00
bCountryCode 0 Not supported
bNumDescriptors 1
bDescriptorType 34 Report
wDescriptorLength 52
Report Descriptors:
** UNAVAILABLE **
Endpoint Descriptor:
bLength 7
bDescriptorType 5
bEndpointAddress 0x81 EP 1 IN
bmAttributes 3
Transfer Type Interrupt
Synch Type None
Usage Type Data
wMaxPacketSize 0x0006 1x 6 bytes
bInterval 10
Device Status: 0x0000
(Bus Powered)
A bit of googling found this: http://members.aon.at/mfranz/warthog.html and this:
http://www.flightgear.org/forums/viewtopic.php?f=24&t=9402 which together would indicate that it's possible to get it working... However, I've run into a wall beyond that. Anyone know any more about getting an hidraw device working with flightgear?